Take a couple of Learning Minutes for yourself.

 

 

 

 

3D Printing is EASY with the Imaginator3D Printer.

 

 

Spend just a few minutes watching the videos below and you'll be on your way to 3D printing like a pro.

These videos are short.
----If you watched them ALL in one sitting, it would take you less than 30 minutes total. BUT, the beauty of these short clips is that you don’t HAVE to watch them all in one sitting. You can start with one super short one, say 2:25.

Everyone can fit 2 Learning Minutes into their day.

To HELP you with your Imaginator3D please watch the following videos found at these links:

http://imaginator3d.com/support/video-tutorials/getting-started-with-your-imaginator-3d/

Leveling the Build Plate – 7.30 minutes

Loading the Filament – 2.25 minutes

Unloading the Filament – 2.09 minutes

Imaginator 3D Nomenclature – 5.58 minutes

Printing with Imaginator 3D from an SD Card – 1.20 minutes

Cleaning a Clogged Nozzle – 5.03 minutes

 

http://imaginator3d.com/support/video-tutorials/troubleshooting-imaginator-3d/

Simple Clog Clearing on the Imaginator 3D – 3.40 minutes

 Note: I’ve not had anyone that actually had a clogged nozzle yet, but at some point it probably will happen. If it happens to you, I would prefer that you use the SIMPLE CLOG CLEARING method to remove the clog. FYI, two schools thought that they had a clog, but it turned out that they had not loaded the filament down far enough into the port. Super easy to identify after watching the video.

 

 You can even have your students watch the videos as part of your Lesson Plan. Students learn thru active participation.

 

 

Don't have a 3D Printer yet?

Contact Josie at schools@bsewinn.com to find out what sort of amazing options exist for your classroom. Some programs will cost you nothing except a willingness to explore the technology.

 

Office:1-888-560-3227 x107 I Text Msg: 918-869-0637